|
Making the cyclic control linkage |
||
|
making the main body
making the cyclic control system an introduction to electronic components ¡@ |
¡@ | As I mentioned before, the Hiller
control system is used in my design. All the cyclic controls are
transmitted to the flybar directly.
¡@
There is a metal bar ironed perpendicularly to the flybar. It holds the metal ball of the ball link in position. Here is how the ball link is made:
¡@ The rob ends are shortened and a metal bar is used to connected them together. the metal bar should be inserted deep into the rob ends and fixed with epoxy adhesive. In addition to the ball link, an anti-rotating unit is a must for the control system. Again, it is made from circuit board.
¡@
In order to stop the lower part of the swashplate from moving, an anti-rotation unit is also needed here. It is simple a small board with two pins inserted on it. ¡@ ¡@ ¡@ here are two video: ¡@ ¡@ |
Ben Hui - web master 2002 |
||
