We repair most Accuphase products-There are parts availability issues with some models, so please get in contact with us before  sending your unit in for repair.

By far the most common Accuphase unit  we repair is the P-300 Kensonic power amp from the 70's. This unit develops problems of long turn on time, noise,  audio dropout etc. If the unit is showing these symptoms but still basically functional it will require a standard overhaul to restore it. We replace all electrolytic caps on the driver, power supply and protection boards, completely resolder all connections, clean all plug in card connectors and go over the bias, gain and offset adjustments. the cost of the service is 375.00

The "E" series of integrated amps and "C" series preamps  are also items we see often, these usually need similar service as  most vintage equipment of this age, no real serious problems as to parts or service procedures. A cost range  of 250-275.00 is common to both series.

A  common annoyance with all  older Accuphase products is the undersized ad difficult to replace ac power cord setup. We can retrofit a heavy duty IEC receptacle and power cord for an additional 38.00 on any unit in for repair.


Most of the newer Accuphase equipment holds up well, with only power supply  or output stage failure. As the equipment is built to a very high standard, we do not advise any component upgrades except replacing power supply resistors with higher wattage types if they fail.