Site hosted by Angelfire.com: Build your free website today!

Up
Power Cable Quiz

Legend911 Power Cable Installation

 

Step 1.

Take the 4-pin connectors from the strip of power supply cables and find the notch that is on one side of the cable end.

Step 2.

Now make the notches turn toward the floor and place them in the appropriate slots on the cd-rom and hard drive.

Step 3.

Make sure that you firmly placed the slot ends in the cd-rom and hard drive.

Step 4.

Take the 16-pin connector from the strip of the power supply cables and find that clip that is on one side of the cable end.

Step 5.

Now make the clip line up with the notch that is on the 16-pin connector on the board that it connects too.

Step 6.

Firmly press the cable down until the clip snap completely over the notch on the connector and check how firmly it is connected.